Beger Tile-Bond Plus

Step 3 Filling Gaps

• Spread a rubber trowel with ready tile grout along the gaps using a 45-degree angle spread to ensure that the grout does not pull the grout out of the gaps.
• After applying the grout, let it set for approximately 60 minutes. Then, remove any excess grout with a damp sponge or cloth and use a dry cloth to clean the surface. 
• It should leave the grout to dry completely for at least 24 hours to improve adhesion before using the area.

Step 1 Surface Preparation 

• Clean and remove any dust and stain on the surface, and then leave it to dry completely. 

Precautions: Fill the gaps with Beger Tile-Bond Plus after tiling for at least 24-48 hours.

Step 2 Mixing Tile Grout

• Mix Beger Tile-Bond Plus with water in a ratio of 3:1 by volume, or mix 1 kilogram of tile grout with 0.32-0.35 liters of water.
• Mix all components thoroughly using a wooden paddle or low-speed drill, and then allow the grout to sit for approximately 3-5 minutes. Stir often while applying.

Step 3 Filling Gaps

• Spread a rubber trowel with ready tile grout along the gaps using a 45-degree angle spread to ensure that the grout does not pull the grout out of the gaps.
• After applying the grout, let it set for approximately 60 minutes. Then, remove any excess grout with a damp sponge or cloth and use a dry cloth to clean the surface. 
• It should leave the grout to dry completely for at least 24 hours to improve adhesion before using the area.