BegerCool DiamondShield Plus

Step 1 Surface Preparation

New Surface:
The substrate must be completely cured and dried for at least 1 month. Measure moisture which should be less than 14%. Remove all dirt, grease, oil, or any contamination completely by washing the surface with a suitable cleaner.

Old Surface (or Repainting):
Any surface problems should be repaired before applying. Clean the surface after fixing the problems. 

• Powdery, chalky, and peeling surfaces must be scrubbed and cleaned with water. 
• Fungus and mildew growth must be cleaned off before applying Beger Mould Free M-001. Left to dry for a day without washing off.
• For the crack width < 1 mm., apply with Beger Acrylic Filler F-200. 
• For the crack width between 2-10 mm., apply with Beger Acrylic Sealant F-100. 

Step 2 Applying Primer

New Surface:

The substrate must be completely cured and dried for at least 1 month. Measure moisture which should be less than 14%. Apply new surface primer Beger Pro 100 or BegerCool Primer #5000 #6000 for 1 coat. Left to dry for 1-2 hrs then coat with interior or exterior paint.

Old Surface:
Apply old surface primer Beger B-1500 B-1700 or B-2500 for 1 coat. Left to dry for 1-2 hrs then coat with interior or exterior paint.

Old and New Surface:

For any kind of surface with moisture between 14-40% and dry for at least 2 days. Applying Beger water block primer B-3100 - High moisture resistant multipurpose primer 1 coat. Left to dry for 2 hrs.

Step 3 Painting

Apply decorative 100% acrylic paint 2-3 coats. Be sure to wait about 2-3 hours between coats to give the fresh paint time to dry. Leave the paint completely dry overnight.